ProLink Linkage Bearing Set – Honda XL600V Transalp 1989-1996

ProLink Linkage Bearing Set for Honda XL600V Transalp 1989-1996

Complete bearing and seal set for the rear suspension ProLink linkage of the Honda XL600V Transalp 1989-1996.

Previous versions had only bushings without bearings.

The set is designed for the refurbishment of worn, corroded or seized rear suspension linkage bearings. Damaged bearings and seals can cause excessive play, restricted suspension movement, unwanted noise and accelerated wear of the linkage collars and mounting components.

The kit contains all needle roller bearings and seals required to overhaul the ProLink linkage. For the best result, we recommend replacing the bearings and seals together with worn linkage collars.

Product features

• Complete bearing and seal set for the ProLink linkage
• Seven needle roller bearings included
• Eight sealing rings included
• Direct replacement for worn original components
• Helps restore smooth and precise suspension movement
• Protects the bearings against dirt, water and corrosion
• Suitable for a complete rear suspension linkage refurbishment

Set contents

• 7× needle roller bearing – 17.5 × 24.5 × 22 mm
• 6× oil seal – 17.5 × 26 × 5 mm
• 2× oil seal – 17.5 × 26 × 2.5 mm

Dimensions are stated as:

inner diameter × outer diameter × width

Compatibility

Honda XL600V Transalp 1989-1996 -best it to check old bearings

Installation recommendation

Before installation, thoroughly clean and inspect the complete suspension linkage. Replace any worn, corroded or damaged collars, bolts and linkage components.

Apply a suitable waterproof bearing grease during assembly. Correct lubrication and properly installed seals are essential for long bearing life, especially on motorcycles used in rain, mud or off-road conditions.

A matching ProLink Collars Set for the Honda XL600V Transalp 1989-1996 is also available separately.